Whites XLT User Manual download pdf (Page 45)

Chapter 5 XLT

Pro Options

GRAPH ACCUMULATE

OFF

TO CHANGE PRESS

ENTER

(Display section)

24. Accumulate

ON combines SignaGraph™ information over

multiple loop passes, OFF shows SignaGraph™

information only from the last sweep of the loop.

Accumulate allows the SignaGraph™ to continually

collect information. This collecting of information

continues from one sweep of the loop to the next.

Eventually, if only ACCUMULATE is selected,

the SignaGraph™ will completely fill, requiring

that the TRIGGER by squeezing and releasing to

clear it so that further information may be viewed.

FADE is suggested to be used in combination with

ACCUMULATE so that non-current information

gradually disappears and excessive TRIGGERing is

not required. FADE will gradually reset or clear the

SignaGraph™ to eliminate old information.

Tips - ON is suggested,

since it takes several

sweeps of information to

recognize trends.

GRAPH AVERAGING

OFF

TO CHANGE PRESS

ENTER

25. Average

Emphasizes the most common or predominate

SignaGraph™ indications.

AVERAGE does not necessarily allow showing of

all the available information on the SignaGraph™.

It averages the information received, and shows this

average on the SignaGraph™. When used in combi-

nation with ACCUMULATE it has more informa-

tion to average, which results in more accurate

indications of trends. FADE is suggested to clear

the display of old information, rather than excessive

TRIGGERing.

Tips - Most beneficial

when used in combination

with ACCUMULATE.

AVERAGE ON is sug-

gested as it reduces

indications uncharacteris-

tic of a particular target,

which may occur due to

loop angle or target

positioning in the ground.

(Display section)

If ACCUMULATE is OFF, and AVERAGE

is OFF, then SINGLE SWEEP is active.

SINGLE SWEEP displays SignaGraph™

information received during the current sweep

of the loop, no more and no less. The next

sweep of the loop will clear all information

from the SignaGraph™ and list the informa-

tion received only within that sweep. Fade is

not needed in the SINGLE SWEEP mode as

each pass of the loop will clear the display

and provide current information automati-

cally. Several SignaGraph™ indication

samples occur during each sweep of the loop.

It is therefore normal to see one or more

SignaGraph™ bars, even in the SINGLE

SWEEP mode.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 55 56

Comments to this Manuals

No comments

Whites XLT User Manual Page 45

Comments to this Manuals

Related products and manuals for Measuring, testing & control Whites XLT